HOME

FORUM

TECH  LIBRARY

SPECIAL VEHICLES REGISTRY

EQUIPMENT REVIEWS

TREAD LIGHTLY!

TRIP REPORTS

Discovery II Spring Height Chart

TYPE DISCOVERY

SPRING USED F/R

HEIGHT FRONT

HEIGHT REAR

Stock Height 2004 SE      19.2”  18.75”
Stock Height 2004 SE7 rear air    

 18.5”

 18.0"

Stock Height 2004 G4   D-18.63" / P-18.5" D-18.88" / P-18.75"
Stock Height 2002 Westminster   18.85" 19"
Stock Height 2002 TJM bumper   18.4" 19"
Stock Height 2001 SE   18.5" 19"
Stock Height 2000 LSE   18.8" 19.2"
       
       
       
         
2004 S winch/rack/sliders BigBlue 2231 BigBlue 2102 21.15" 21.6"

Same vehicle as above, redone

BigBlue 2104 BigBlue 2102 21.25" 21.4"
2004 SE RTE RTE 21.75" 22.15"
2004 SE7 rear air/rack BigBlue 2104 BigBlue 2102 21.25" 21.05"
2004 S7 winch/sliders/f&r bumpers RTE 2 RTE 2 21.8" 20.4"
2004 S sliders Stock Rear RTE RR3-2 22.0" 21.0"
2004 G4 SD rack/brush bar   OME 779 OME 763 (L/R swapped) D-21.38" /P-21.5" 21.18"
         
2003  SE7 OME 777 OME 762 20.75" 20.5"
2003 S  rear AC, no rear seats ?! BigBlue 2104 BigBlue 2103  21.25" 21.00"     DI spring seat
2003 S  rear AC, no rear seats ?! BigBlue 2104 BigBlue 2102 21.75" 22.00"    DII spring seat
         
2002 S RTE 2 RTE 2 22.2" 20.2"
2002 S winch/sliders RTE 2 RTE 2 21.6" 20.25"
         
2001 winch/sliders OME 751 OME 781 D-21.0" / P-20.75 D-21.5" / P-21
2001 winch/sliders/rack RTE 3 RTE 3 D-22.25" / P-22" D-22.0" / P-21.5"

2001 SD winch/sliders

OME 779 (HD) OME (MED) D-20.75" / P-21.00" D-21.75" / P-21.25
2001 SD BigBlue 2104 BigBlue 2103 21.25" 21.00"   DI spring seat
         
2000 SE F/R bumpers, sliders RTE 2 RTE 2 21" 19.6"
2000 SD F/R steel bumpers RTE 2 RTE 2 21.5" 20.10"

Same vehicle as above, redone to correct sag

BigBlue 2104 BigBlue 2102 21.25" 21.1"
2000 SD sliders RTE 2 RTE 2 21.25" 20.85"
2000 LSE BigBlue 2104 BigBlue 2102 21.75" 22.2" (using DI spring seat, intended for towing)
2000 SD  F bumper/winch BigBlue 2104 BigBlue 2102

21.25"

21.5"

         

 

If you have a lift on a Discovery, please submit your measurements!  All measurements are taken from the centre of the wheel hub straight up to the bottom of the wheel arch.  This measurement is easier than measuring the spring from perch to perch (spacers can play with that measurement as well) and the results of this method don't change with tyre size.

As a general rule, any more than 3/4 inch difference front to rear results in an unbalanced look. The rear wheel arch is lower in the body than the front, so a slightly lower measurement on the rear will result in a level vehicle but should not exceed 3/4".

 

Stock measurements are welcome to help identify differences in the years and trim levels!

 

 

 

Copyright © 2008, MuddyOval.com